Displays and indicators

  • 1
  • 2
  • 3
  • 4
  • 5

Displays and indicators

Selection of views

Depending on the vehicle, use control 1 to browse and select the various views on the instrument panel.
Several views are proposed:
  • charging view: displays the range, battery percentage and remaining charging time on the instrument panel only when the vehicle is charging;
  • classic view: displays the speed, active driving aids, information area and, depending on the vehicle, the power meter on the instrument panel;
  • navigation view: displays the speed, active driving aids and the information area on the instrument panel. It also duplicates the road map from the multimedia system onto the entire instrument panel;
  • realistic scene: displays the speed, active driving aids, information area as well as your vehicle and its surroundings (lanes, vehicles around you, etc.) on the instrument panel;
  • minimum view: displays only essential information, the speed, active driving aids and the information area on the instrument panel.

Instrument panel 

lights up when the driver’s door is opened. In some cases, the appearance of a warning light is accompanied by a message.
Depending on the vehicle, you can customise your instrument panel with the content and colours of your choice.
Please refer to the multimedia instructions for more information.

Speedometer 2

Excessive speed audible alarm
Depending on the vehicle and country, the warning light is displayed and a beep sounds. This beep sounds as soon as the vehicle is travelling at over 75 mph (120 km/h).
This warning light remains lit for as long as the vehicle is travelling at over 75 mph (120 km/h).

Information on driving aids 3

Navigation in progress information 4

Depending on the vehicle, you can display information from the multimedia screen (compass, telephone, navigation, etc.) or information from the trip computer.
Please refer to the multimedia instructions for more information.

Battery information 5 (traction battery charging rate, estimated range)

Power meter 6

Total mileage recorder 7

Regenerative braking level warning light 9

Information area 8

Depending on the vehicle, use the control 10 to browse and select the various widgets on the instrument panel:
  • trip computer information (mileage recorder, consumption, etc.);
  • telephone, multimedia (audio source currently playing, etc.) information;
  • vehicle information (warning messages, etc.);
  • ...

Charging cable "Plugged In" warning light 11

This comes on when the charging cable is plugged into the vehicle.

Charge level 12

The gauge indicates the level of energy remaining.

Remaining charge time 13

Traction battery charge rate 14

Reserve threshold

When the traction battery charge reaches approximately 7% or, depending on the vehicle, approximately 12%, the gauge and indicator light15 appear in yellow, accompanied by a beep.
To optimise your range DRIVING ADVICE, ECO-DRIVING.

Immobilisation threshold imminent

When the charge level reaches about 4% or, depending on the vehicle, about 6%, a beep will sound again and the meter will light up in red or, depending on the vehicle, 30 seconds after the meter lights up in red.
When the charge level reaches 3.5% or, depending on the vehicle, approximately 5%, the range value is no longer displayed. Engine performance gradually decreases until the vehicle comes to a halt BREAKDOWN RECOVERY.

Estimated range 16

High 17: visibility of range in optimal conditions (e.g. driving on A-roads or dual carriageways with little use of thermal comfort).
Low 18: visibility of range in adverse conditions (e.g. driving on a motorway in winter or in a traffic jam with intensive use of thermal comfort).
To optimise your range DRIVING ADVICE, ECO-DRIVING.

Instrument panel in miles

(option to switch to km/h)
With the vehicle stationary and the engine switched on, from the multimedia screen 19 select the "Vehicle" World, press the "Settings" menu, "Units" then "Speed".
Choose between km/h or mph.
The speedometer and some of the distance information displayed on the instrument panel are converted.
To return to the previous mode, repeat the same operation.
Note: once the battery is switched off, the trip computer automatically returns to the original unit of measurement.
Please refer to the multimedia instructions for more information.
Tip
To use certain driving aid functions, it is necessary to change the unit of measurement on the instrument panel in order to obtain the appropriate information when driving in a country where the speed units differ from those set as default on your vehicle.
WARNING
For safety reasons, carry out any adjustments while the vehicle is stationary.